Car Park Clearance Heights in Australia: What Your Bay Needs

The Short Version

  • Australian car parks are designed to a standard, but your bay's real clearance is usually lower than the design figure.
  • Pipes, ducts, sprinkler heads and beams are what set your actual limit, not the ceiling slab.
  • Accessible bays are held to a taller clearance and shouldn't be obstructed.
  • The Kookaburra needs at least 2.1m from the floor to the lowest point overhead, with legs adjusting from 2.05m to 2.35m.
  • Measure to the lowest thing above your bay, then check the fit before you order.

Why clearance varies so much between buildings

Car parks in Australia are designed against AS/NZS 2890.1, which sets minimum headroom for standard parking spaces and the routes into them. Councils layer their own requirements on top, and you can see how that works in practice in Moreton Bay's design guidelines for parking.

The catch is that the design figure describes what the building was built to, not what's above your particular bay today. Services get added. Ducting runs where it needs to run. A bay next to a ramp can sit under a sloping soffit. Two bays on the same level can differ by 300mm.

If you want the background on what the standard covers, there are good plain-English explainers on the Australian standards for car park compliance, on AS2890.1 headroom requirements specifically, and on how AS2890.1 compliance is assessed.

The number that matters is the lowest thing above your bay

For working out whether storage will fit, the design standard is background. What counts is the shortest distance between your floor and anything overhead within your bay.

Measure to whichever of these sits lowest:

  • Sprinkler heads and their pipework
  • Air-conditioning ducts and exhaust runs
  • Electrical conduit and cable trays
  • Down-stand beams, especially near columns and ramps
  • Lighting and signage

Take the measurement in a few places across the bay, not just the middle. A duct crossing the front of the bay can be the deciding factor even when the rest of the ceiling is generous.

Our car park ceiling height guide walks through doing this properly, including where people usually go wrong.

Accessible bays and shared routes

Accessible parking spaces are held to a taller clearance than standard bays, because they have to accommodate vehicles with roof hoists and raised roofs. The access aisle beside them and the route in also need to stay clear.

If your bay sits next to an accessible space or on a shared access path, keep storage entirely within your own bay and clear of that route. It's the kind of detail a committee will notice, and a fair reason for them to say no if it's ignored.

What this means for over-bonnet storage

The Kookaburra needs at least 2.1m from the floor to the lowest point overhead. Its legs adjust between 2.05m and 2.35m, so the same unit suits a range of buildings, and the less clearance you have, the lower your bonnet needs to sit underneath it.

It's 2.35m long and 1.0m deep, holds 2.3m³, and is rated to 500kg across that whole adjustable height range. It suits many sedans, hatchbacks, SUVs, 4WDs and utes, though that depends on your bay and your vehicle.

Two things worth checking beyond the headline number:

  1. Where the low points sit. A bay with 2.4m of slab height but a duct at 2.05m is a 2.05m bay.
  2. Fire services. Nothing should obstruct a sprinkler head, hose reel or extinguisher, and committees ask about this early.

The quickest way to settle it is the online compatibility check. If you don't have measurements, we can check from a photo, and if you're close to the minimum our team can verify on-site. Fit is confirmed before you order.

Entry height restrictions are a separate question

The clearance above your bay isn't the only height in a car park. Entries often have a height restriction bar or gate set below the structural clearance, to stop oversized vehicles getting in and hitting something further along.

That bar is about vehicle access, not about your bay, and car park gates and access barriers are set by the building rather than by the standard alone. It matters for whether a delivery van can get in on install day, which is worth checking before booking.

Frequently asked questions

What clearance height do I need for over-bonnet storage?

At least 2.1m from the floor to the lowest point overhead. The adjustable legs cover 2.05m to 2.35m, and the less clearance you have, the lower your vehicle's bonnet needs to sit.

Do I measure to the ceiling or to the pipes?

To the pipes, ducts, sprinklers or beams, whichever is lowest within your bay. The slab height is not the usable height.

Does an over-bonnet unit need council approval?

Council is generally not involved in adding a freestanding storage unit to an existing bay. Approval usually comes from your body corporate under the building's by-laws. Check your by-laws and speak to your strata manager.

What if my bay is close to the minimum?

Contact us before ordering. We can check compatibility from your measurements or a photo, and verify measurements on-site when a bay is borderline.