Steel is steel. Two units can use the same gauge and one will still look tired years before the other, because what sits on the surface is doing the work.
Car parks are harder on a finish than people expect. They're humid, they collect road grit and salt carried in on cars, and on the Gold Coast and in Brisbane's bayside suburbs there's salt in the air as well. A finish that would last decades in a spare bedroom has a different life in a basement two streets from the water.
Powder coating is a dry powder applied electrostatically and then baked, so it flows into a hard, even skin. It resists chipping better than liquid paint and comes in almost any colour. This guide to powder coatings covers how the process works if you want the detail, and the industry body publishes a lifecycle and sustainability overview covering how the material behaves over time.
Electrocoating, or e-coat, is applied by immersing the part and using an electric current to deposit an even film, including into corners and seams a sprayed finish can miss. That coverage is the point: rust usually starts at an edge or a fold, not in the middle of a flat panel. The Kookaburra uses an electrocoated finish, intended to improve corrosion resistance.
Hot-dip galvanising is different again. The steel is dipped in molten zinc, which bonds to it and corrodes in its place. It's the toughest of the three in brutal conditions and the least refined to look at. This comparison of hot-dip galvanising and powder coating sets the two side by side, and some products use both, galvanising first and coating over the top.
You'll see coatings advertised with a lifespan in years. Treat those as a range, not a promise. The same finish behaves very differently depending on how the steel was prepared before coating, how thick the film is, whether it lives indoors or out, and how much salt reaches it. This look at how powder coated metal ages outdoors in Australia gives a sense of the spread.
For a car park unit, the useful questions aren't about the number. They're:
An over-bonnet unit has an advantage on that last point, because it sits above the bonnet rather than on the slab.
If you want to see how the finishes hold up in practice, look at what else lives outdoors in Australian weather. Powder-coated gates and wrought iron work face full sun, rain and salt with no shelter at all, which is a harder test than a basement car park.
There's an environmental angle too. Powder coating produces very little waste because oversprayed powder can be recovered and reused, and it releases far fewer solvents than liquid paint. This piece on the environmental side of powder coated steel covers that in more depth.
None of these finishes need much, but a little goes a long way:
When you're comparing units, ask for the specifics rather than the adjective:
The Kookaburra is all-steel with an electrocoated finish and closed panels that help shield gear from dust and dirt. It carries a 5-year structural warranty, plus Lifetime Parts Cover on the original lock mechanism and gas struts for the original purchaser. It isn't sold as waterproof, so it's worth keeping anything moisture-sensitive in a sealed box inside it.
No. It uses an electrocoated finish, which is applied by immersion so it reaches seams and folds evenly. It's intended to improve corrosion resistance.
Any steel will rust if the finish is breached and salt reaches it. A coated, raised unit that's wiped down occasionally and kept closed holds up well. Deep scratches are the thing to repair rather than ignore.
For exposed outdoor structures, galvanising is very hard to beat. For an enclosed car park, a properly prepared coated finish is doing a different job, and looks considerably better while doing it.
Not usually. Committees care much more about whether the unit is freestanding, whether it obstructs fire services, and how it's installed. Our body corporate approval guide covers what they do ask for.